WITECH MicroPod 2 V17.04.27 Register, Install Problems and Solutions
Car Diagnostic Tool / March 26, 2020

Here have collected some WITECH MicroPod 2 V17.04.27 problems incl. register, installation and using. And also share the related solutions from obdiitool.co.uk.   1.  Using Error:  I used the wiTech MicroPod 2 V17.04.27 software and instructions and reinstalled multiple times to make sure it was setup as instructed. I have tried this on a 2005 Chrysler PT Cruiser and a 2003 Dodge Durango. When going to check the Engine Diagnostics, it gives the error “NO RESPONSE from PCM” as shown below:   Then the following error pops up as well.   obdiitool.co.uk engineer solution: The device you use is DRB3 emulator. DRB3 only can support Chrysler vehicles till year 2004. It’s also not very stable to use. It’s better to choose wiTECH VCI Pod.   2. Register Error: 1).A message prompts “Device with serial number WSP-*** is not registered. Please check the knowledge base to determine how to register a device” when registering wiTech MicroPod 2.     obdiitool.co.uk engineer solution: It’s easy to solve, just refer to this article: http://blog.obdiitool.co.uk/solved-witech-micropod-2-cannot-register/   2).When register MicroPod 2 V17.04.27, it prompts “Access refuse”. Here are two error pictures as below.   obdiitool.co.uk engineer solution: The prompt is indicating that the software is…