If your Autel MaxiIM IM608 appears screen hopping during operation, it starts to click randomly on the screen by itself without anyone touching the device [e.g. it automatically jumps back to the main menu from other interface (view the figure as below)], it means there is something wrong with the touch screen. You need to purchase a new touch screen to change. It’s not difficult to replace it by yourself, just follow the guide offered to do.
Guide to change touch screen and LCD screen:
Note: the device used is MaxiSys Ultra, but the guide also applies to MaxiIM IM608.
1).Prepare a new top shell and a new LCD screen. Make sure that they are goodones;
2).Refer to following image to install the LCD screen on the holder;
3).Tighten four screws (Torque of electric screwdriver: 1.5±0.2kgf.cm)
4).Stick 4pcs screw gasket to the places circled in red
5).Stick acetic acid tape to the places circled in red
Notice:
a.Do not stick acetic acid tape to the LCD screen;
b.Stick 1pcs acetic acid tape to every place
6).Remove the protectors from LCD screen and touch screen. Use air gun to clean top shell and LCD screen and use a dust-free cloth with alcohol to wipe blots;
Notice: When tearing off the protectors, please start from the top right corner and work against the ion blower to prevent static electricity from damaging LCD or TP
7).Assemble the top shell and the LCD screen. Make sure that the camera is well installed
8).Tighten all the screws.
Tech support:
