Here share the solution to fix J1850 PWM protocol module programming bugs using SVCI J2534 diagnostic tool.
Something important to know:
The Ford IDS firmware must be upgraded to V001.031 or the latest version.
Test module information:
Part number: F8CF-12A650-CE
Year: 1998
Module: ECU
Protocol: J1850 PWM
Test target: Module programming
The solution:
Connect SVCI J2534 Ford with computer and ECU module
Run Ford IDS integrated diagnostic software (IDS 120.01)
Upgrade firmware to V001.031
After the upgrade procedure is done, open IDS software again, and you can see the firmware version has been upgraded to newest one.
If the language is Chinese, you can change it to English by clicking the related icons as shown in the following figure.
Then select “Start New Session”-> “All other”, and it will establish communication to PCM and show the corresponding vehicle specification to confirm
The VIN will also appear automatically, just click the tick icon to continue.
Click the red icon-> select “Module Programming”
Select “Programmable Module Installation”-> “PCM”
Set ignition switch to OFF (Position 0) (Disconnect SVCI J2534 tool and ECU module)
Install a new module in vehicle-> click the tick icon
Pay attention to the following info carefully:
Do not start a reprogramming session with a low battery in the vehicle and/ or programming tool.
The fuel pump and the engine cooling fan(s) may run during the following procedure. If you are programming a 6.0L diesel, the FICM relay must be removed before programming.
Set the ignition switch to ON (Connect SVCI J2534 tool and ECU module again)
It starts reprogramming PCM and will take about 4 minutes, please keep patient.
Then follow the prompt to set ignition switch to OFF…ON…OFF till it shows “Calibration has been loaded and checked”.
Note: If you programmed a 6.0L diesel, please reinstall the FICM relay.
If required, obtained a PCM reprogramming label and complete with the following data in the prompt. A reprogramming label is not required on vehicles serviced in North America.
Place the completed label in the appropriate position.
Then start engine, do not depress the throttle pedal!
Set ignition to OFF (position 0)…ON, and it starts clearing the fault codes
Finally set ignition switch to OFF
Done!
Learn more:
SVCI J2534 Mazda Problems & Solutions
SVCI J2534 Ford IDS V117 Free Download & Install